Ingersoll Rand Model 244 Mode D'emploi page 3

LUBRICATION
Ingersoll–Rand No. 50
Always use of an air line lubricator. We recommend the
following Filter–Lubricator–Regulator Unit:
For USA – No. C28–04–FKG0–28
Before starting the Tool and after each eight hours of
operation, unless the air line lubricator is used, detach the
air hose and inject about 3 cc of Ingersoll–Rand
No. 50 Oil into the Air Inlet.
After each forty–eight hours of operation, or as
experience indicates, inject about 4 cc of Ingersoll–Rand
No. 100 Grease into the Grease Fitting (16).
INSTALLATION
Air Supply and Connections
Always use clean dry air. Dust, corrosive fumes and/or
excessive moisture can ruin the motor of an air tool.
Model
244
244–2
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 100
SPECIFICATIONS
Type of
Handle
pistol
pistol 1/2" sq. with extended
anvil
An air line filter can greatly increase the life of an air tool.
The filter removes dust and moisture. Be sure all hoses
and fittings are the correct size and are tightly secured.
See Dwg. TPD905–1 for a typical piping arrangement.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Drive Impacts per min.
in.
1/2" sq.
3
FILTER
COMPRESSOR
(Dwg. TPD905–1)
Recommended
Torque Range
ft–lbs (Nm)
1,300 40–350
(54–474)
1,300 40–350
(54–474)