MINN KOTA TALON Manuel Du Propriétaire page 8

INSTALLATION
4
ITEM(S) NEEDED
#2 x 4
NOTICE:
It will be necessary to have a second
person hold the Tilt Bracket open during this step
of the installation.
h. With the Tilt Bracket still in the open position, mount
the Mounting Bracket to the Tilt Bracket. Take four
5/16-18 Hex Head Cap Crews (Item # 2) and place
one 5/16" Flat Washer (Item #8) on each. With the
Tilt Bracket in the open position and aligned with the
Mounting Bracket, put one Bolt in each of the four
Mounting Holes to join the two pieces.
NOTICE:
Take note of the orientation of the
mounting hardware. The heads of the bolts must
be installed to the inside of the Tilt Bracket. The
Stainless Steel Washers provided must be used on
the outside of the Tilt Bracket.
i. Take four .750 X .3125 Thick Stainless Steel
Washers (Item #10), four Lock Washers (Item #6)
and four Nylock Nuts (Item #4) and place anti-
sieze (Item #12) on all of the hardware. Place one
Stainless Steel Washer, followed by a locking washer
and Nylock Nut on the end of each bolt.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize will help prevent seizing.
j. Verify that all mounting hardware is tightened to 30
ft-lbs and secure.
CAUTION
Periodically check that all 8 sets of bolts installed are at
the recommended torque of 30 ft-lbs to ensure proper
operation and tight hardware.
8 | minnkotamotors.com
#6 x 4 #8 x 4 #10 x 4
4h
Outboard
Tilt Bracket
#12 x 1
#4 x 4
Nylock Nut
Lock Washer
Thick Stainless
Steel Washer
Mounting
Bracket
Flat Washer
Hex Head
Cap Crew
Inboard
©2019 Johnson Outdoors Marine Electronics, Inc.