MINN KOTA TALON Manuel Du Propriétaire page 7

2
ITEM(S) NEEDED
d. If the Mounting Bracket is already mounted to an
adapter bracket, remove the Mounting Bracket from
it. Any hardware that was holding the Mounting
Bracket to an adapter bracket should be discarded.
Do not reuse the old hardware.
e. Take the Tilt Bracket (Assembly #A) and align it
with the Mounting Holes on the Flag Mounting
Plate Bracket. The Tilt Bracket should be oriented
so that the Latch Lever is positioned upward and
facing inboard.
3
ITEM(S) NEEDED
#2 x 4
f. Push in the Latch Lever to open the Tilt Bracket.
Take four 5/16-18 Hex Head Cap Crews (Item #2)
and place one 5/16" Flat Washer (Item #8) on
each. With the Tilt Bracket in the open position and
aligned with the Flag Mounting Plate Bracket, put
one Bolt in each of the four Mounting Holes to join
the two pieces.
CAUTION
Watch for pinch points between the Talon Tilt Bracket and
the Tilt Bracket Arm when installing and using the bracket.
g. Take four .750 X .3125 Thick Stainless Steel
Washers (Item #10), four Lock Washers (Item #6)
and four Nylock Nuts (Item #4) and place anti-
sieze (Item #12) on all of the hardware. Place
one Stainless Steel Washer, followed by a locking
washer and Nylock Nut on the end of each bolt.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize will help prevent seizing.
©2019 Johnson Outdoors Marine Electronics, Inc.
#A x 1
#6 x 4 #8 x 4
2e
Outboard
Mounting
Holes
Tilt
Bracket
Mounting
Holes
#10 x 4
3f
Latch
Lever
Tilt
Bracket
3g
Hex Head
Cap Crew
Flat Washer
Inboard
INSTALLATION
Latch Lever
Mounting
Flag Mounting
Holes
Plate Bracket
Mounting
Inboard
#12 x 1
#4 x 4
3f
Mounting
Holes
Thick
Stainless
Steel Washer
minnkotamotors.com | 7
Holes
Outboard
Lock
Washer
Nylock
Nut