MINN KOTA TALON Manuel Du Propriétaire page 11

3
g. Loosen the Support Leg Locking Screw until the
Support Leg moves freely.
h. In order to determine the best position for the
Support Leg, release the Talon Tilt Bracket by
pressing on the Locking Lever. With the Talon
supported, lower the Talon in the Tilt Bracket.
CAUTION
While performing work on the Talon or boat, make sure the
weight of the Talon is supported when the Tilt Bracket is
engaged to Tilt the Talon. If the Talon is not supported, the
Talon can fall and cause injury to people or property. Avoid
the risk of injury by supporting the weight of the Talon.
i. Pull out on the Deck Support Pivot and rotate it 90
degrees. The pivot will lock into its "in use" position.
4
j. Position the Support Leg Pivot along the length of
Talon between the Talon top cover and the Talon
Motor in the best location for your boat. Tighten the
Support Leg Pivot into place using the ¼" Allen
wrench.
k. Adjust the Leg length to one of the machined slot
locations that works best and retighten the Locking
Screw that was loosened previously.
l. Adjust the Leg Tip Support position according to
the adjusted Support Leg length, so that the end of
the Leg will rest in the Cradle. Tighten the Leg Tip
Support using a 7/32" Allen Wrench.
©2019 Johnson Outdoors Marine Electronics, Inc.
3g
Support
Leg
Support
Leg
Locking
Screw
3i
Deck
Support
Pivot
Support
Leg
4j
Top Cover
Talon Motor
Support
Leg Pivot
Leg Tip
Support
Support
Leg
INSTALLATION
3h
minnkotamotors.com | 11