MINN KOTA TALON Manuel Du Propriétaire page 10

INSTALLATION
Installing the Adjustable Deck Support
1
ITEM(S) NEEDED
a. With the power still disconnected from the Talon,
remove the top cover from the Talon using a #2
Phillips screw driver. There are a total of 2 or 4
screws holding the cover in place.
WARNING
To avoid electric shock or unexpected Talon operation, make
sure the Talon is not connected to a power source.
b. Install the Leg Tip Support (Assembly #E) on the
Port (left) side of the Talon. Do this by loosening the
Square Nut until it is flush with the end of the screw.
c. Slide the support into the Assembly Track making
sure the Washer is on the outside of the track and
the Square Nut is on the inside of the track.
d. Position the Leg Tip Support against the top edge
of the Talon Motor Cover for the moment. The final
position of this support will be determined later.
2
ITEM(S) NEEDED
e. Take the Deck Support Pivot (Assembly #D) and
install it by loosening the Square Nut until it is
flush with the end of the Shoulder Bolt Threads.
Slide the support into the Assembly Track of the
Talon. Make sure the washer is on the outside of
the Talon and the Square Nut is on the inside of the
track. The installed Deck Support Pivot will already
have the Support Leg installed. Do not completely
tighten any of the fasteners at this time.
f. Reinstall the Talon cover that was removed. Tighten
all four screws securely.
10 | minnkotamotors.com
#E x 1
#D x 1
NOTICE:
Take care not to damage wires on the Talon
Cover for Talons that are equipped with a Work Light.
1a
Talon
Assembly
Cover
Track
Talon
1b
Talon
Assembly
Track
Leg Tip
Square
Support
Nut
2e
Deck
Support
Pivot
2e
Square
Deck
Nut
Support
Pivot
1c
Assembly
Track
Leg Tip
Support
Talon
Motor
Cover
2f
Talon
Cover
2f
Deck
Talon
Support
Cover
Pivot
©2019 Johnson Outdoors Marine Electronics, Inc.