MINN KOTA TALON Manuel Du Propriétaire page 6

INSTALLATION
2. The Talon Tilt Bracket can only be installed with the use of a Talon Adapter Bracket (Pontoon Bracket 1810225, Jack Plate 1810340
or sandwich style Adapter Brackets 1810302 for Port or 1810303 for Starboard) to ensure proper clearances at the pivot point. Direct
transom mount applications will not have proper clearance.
Your Talon MUST be kept in the upright and locked position while trailering, and while under main engine power at anything higher
than idle speeds.
Complete Typical Installation
Tilted (Down) Position
INSTALLATION
Mounting the Tilt Bracket
1
a. Disconnect the Talon from power before beginning
the installation.
WARNING
To avoid electric shock or unexpected Talon operation, make
sure the Talon is not connected to a power source.
b. Remove the Talon from the Talon Mounting Bracket
by loosening the 4 Nylock Nuts that hold the Talon
in place. Do not remove the nuts, only loosen them.
It may be necessary to have a second person holding
the Talon while the Nylock Nuts are being loosened.
c. Lift the Talon out of the Mounting Bracket and set
it aside.
6 | minnkotamotors.com
WARNING
Tilted (Up) Position
NOTICE:
help with this installation.
1a
Power
Cables
Talon
It may be necessary to have a second person
1b
Nylock
Nut
Outboard
©2019 Johnson Outdoors Marine Electronics, Inc.
Inboard
Talon
Mounting
Bracket
Talon