Remote Control; Battery Replacement - RELAXXNOW VTX200 Manuel

12. REMOTE CONTROL

Note:
Remove the plastic insulation tab under the battery before using the remote con-
trol.
Operation is subject to the following two conditions:
1. This device does not encounter transmission interference, and
2. this device necessarily picks up any interference, including interference that may result
in the compromised performance of the device.
• The remote control must be pointed at the receiver on the fan in order to work.
• The range of the remote control is 5 meters. If the remote control is not aimed at the
receiver, the range will be reduced.
• The remote control should not be used in rooms where heavy machinery is in opera-
tion.
• The line of sight between the remote control and the receiver must not be blocked.
• Carefully handle the remote control. Do not drop it and do not collide it against hard
objects.
Guidelines for Using the Batteries of the Remote Control
• If the remote control will not be used for an extended period of time,
remove the batteries from the remote control.
• Clean the battery contacts and the device before putting the battery
in the remote control.
• Make sure that the batteries are inserted correctly, especially with regard to polarity,
by adjusting the +/- sides of the battery to the corresponding indicators on the remote
control.
• Remove used and damaged / discharged batteries immediately.

Battery Replacement

To change the remote control battery, insert the tip of a pen into the hole on the back
of the remote control while gently pulling on the battery compartment cover. Once the
battery cover is removed, remove and replace the battery. When inserting the battery
again, please observe the polarity placement, which is indicated on the back of the
remote control.
42
RELA NOW