RELAXXNOW VTX200 Manuel page 39

ROTOR & GRIDS
F
1
(Fig. 3)
A Remove and discard the plastic packaging of the motor shaft (#7).
B Guide the rear grill with the handle (#5) along the motor shaft (#7) against the front
of the motor unit (#8). Make sure that the handle on the back of the rear grill (#5) is
facing up and that all the guide pins on the motor unit (#8)
are aligned with the recesses on the rear grill.
C Secure the rear gate with handle (#5) with the plastic nut (#4). To do this, firmly attach
the plastic nut (#4) to the motor unit (#8) by tightening it clockwise.
D Guide the fan blade (#3) along the motor shaft (#7) against
the plastic nut (#4). Carefully turn the fan blade (#3) into the correct position until the
recesses provided for it engage in the plastic nut (#4).
E Now place the turntable (#2) on the motor shaft.
It is fastened by tightening the turntable (#2) counterclockwise.
F Mount the front grill (#1) against the rear grill (#5) by aligning the markings on the top
accordingly. Now connect both parts using the hooks on the
front grill (#1) and the slots on the rear grill (#5). Carefully pull the snap lock pin
outwards and turn the front grill (#1) clockwise to the locking position.
The snap lock pin should now snap into place.
E D
2 3
A
7
C B
4 5
8
EN
39
RELA NOW