Commissioning; Electrical Connection - RELAXXNOW VTX200 Manuel

Note:
To disassemble the front grill, gently pull the snap lock pin outward while rotating the
front grill counterclockwise.
Tighten the locking screw to secure the snap lock pin.
(Fig. 4)
1. Fit and align

10. COMMISSIONING

Electrical connection

• Before plugging the power plug into the power outlet, make sure that the voltage of your
main power supply matches the voltage on the product label.
• Only connect the fan to a properly installed contact socket.
IMPORTANT
1. Please observe the minimum surrounding distances to walls and objects when installing
the device (30cm in ALL directions).
2. Before startup, check the condition of the power cord. If in doubt about the condition,
contact the manufacturer.
3. Position the device in an upright AND stable position.
4. Avoid laying the power cord (when positioning in the center of the room). Avoid the cable
beng a „tripping hazard" of any kind. We recommend the use of cable bridges/covers.
5. Make sure the power cord is fully unrolled.
6. Make sure that possible objects (such as curtains, clothing, etc.) do not obstruct the airflow.
7. Insert the batteries into the remote control. If the batteries are already inserted into the
remote control ex works, you must remove the protective foil.
40
RELA NOW
3. Pull the locking pin
2. Turn the front grill 4. Locked