vitapur VWD1076BLST Guide D'utilisation Et D'entretien page 13

Troubleshooting
Problem
Water dispenser
is leaking
Water is not hot
or cold enough
Hot water heating
not working
Water dispenser
is not dispensing
water
Water dispenser
is noisy
Note:
Do not return this product to the store. For questions on operation, assembly or
parts, please contact Customer Service at 1-877-447-4768 and ask for assistance
Possible Cause
Drain cap and silicone seal are not
secure.
The heating/cooling cycles are still
in progress (i.e. LED Halo lights
still flashing).
The unit is unplugged.
"Kettle" Feature was not activated.
Lower front panel is not installed.
The circuit breaker in your home is
tripped or the fuse has blown.
Temperature hi-limit thermostat
protection switch tripped.
Cold water control needs to be
adjusted.
Empty water bottle.
Mineral deposits clogging tanks.
Lower front panel is not installed.
Water pump makes noise as it fills
the tank.
Water dispenser is uneven.
Suggested Solution
Ensure drain valve, silicone
plug and drain cap are securely
tightened.
Wait for LED lights to stop flashing.
Plug it into the outlet.
Activate "Kettle" Feature by
pressing the button #4.
The lower front panel must always
be installed/positioned on the unit
for proper operation.
Reset the breaker or replace the
fuse.
Allow the temperature of the
hot water tank to cool for
approximately 15-30 minutes.
The temperature limit thermostat
will re-set automatically once
sufficiently cooled and will
reactivate automatically. To
operate the hot water system,
press the hot water heating
activation button #4.
Adjust cold water control (K)
between high (cool) and low
(colder) levels to achieve desired
temperature.
Replace with full bottle.
See Cleaning the Reservoirs.
The lower front panel must always
be installed/positioned on the unit
for proper operation.
This is normal.
Make sure the dispenser is on an
even surface that can support its
full weight.
.