Table des Matières
Publicité
FRAMER'S
F. Re-Square the Squaring Arm
TOOLS NEEDED: Screwdriver, Carpenter's Square.
ATTENTION: It is common for 32" x 40:" sheets of mat board to be un-square
when bought. Take this into account before making any adjustments to the
Squaring Arm.
Before making any adjustments to the squaring arm, make sure that the machine is truly
out of square, not the matboard, by using the squareness test.
SQUARENESS TEST
1. Place the carpenter's square against the right hand side of the cutting bar and down
against the squaring arm. Look to see if there are any gaps between the carpenter's
square and the squaring arm. If so, the squaring arm needs to be adjusted. Fig 6
TO RE-SQUARE
1. By looking at where the gap is, you can determine which way the squaring arm
needs to go in order to be square again.
2. Remove the squaring arm and locate the three screws inside of the slot.
3. Adjust only two screws A&B, DO NOT ADJUST C. To adjust you must turn screws A
& B in equal but opposite directions. To move the far right end of the squaring arm
towards the top end of the machine, turn adjustment screw B outward (counter-
clockwise) about a quarter turn and adjustment screw A inward (clockwise) a
quarter turn. Fig 7
4. Re-install the squaring arm and check for square. Make additional adjustments until
square.
12
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
EDGE
M AT C U T T E R MODELS 650, 655 & 660
Place square here
Fig 7
Fig 6
Publicité
Table des Matières
