Using The Appliance; Lamp Replacement - Beko CFB 9433 X Mode D'emploi

3

Using the appliance

3.1 Controls panel
L Light
Switches the lighting system on and off.
V Speed Sets the operating speed of the extractor:
0. Speed switches the extractor motor off.
1. Low speed, used for a continuous and
silent air change in the presence of light
cooking vapour.
2. Medium speed, suitable for most ope-
rating conditions given the optimum
treated air flow/noise level ratio.
3. Maximum speed, used for eliminating
the highest cooking vapour emission,
including long periods.
• The extractor hood has been designed exclu-
sively for domestic use to eliminate kitchen
smells.
• Never use the hood for purposes other than for
which it has been designed.
• Never leave high naked flames under the hood
when it is in operation.
• Adjust the flame intensity to direct it onto the
bottom of the pan only, making sure that it does
not engulf the sides.
• Deep fat fryers must be continuously monitored
during use: overheated can burst into flames.

3.2 Lamp replacement

• Before replacing the light bulbs,
disconnect the power supply of
A the hood.
• Do not touch the light bulbs when
they are hot.
• Be careful not to touch the repla-
ced light bulb directly with hands.
C
You may procure lamps from
Authorised Service Agents.
Hood / User Manual
Lamp
Power
Socket
Voltage
Dimension
ILCOS Code
• Candle type HALOGEN lamp is used in this pro-
duct
• Max 28 W lamp must be used when the change
of lamp
28 W
E14
220 – 240
107x37 mm
D R B B / F - 4 - 2 2 0 -
240-E14-35/100
9 / EN