Maintenance; Care And Maintenance - GoodHome hyana 500W Mode D'emploi

Care and Maintenance

35
CLEANING
Before cleaning, make sure the appliance is turned off, cold and
disconnected from the household mains.
To clean, just wipe with a soft damp cloth and neutral detergent. Never use
abrasive or corrosive cleaning products or solvents.
To maintain efficiency, remove the dust from the surface and inside of the
appliance at least twice a year using a vacuum cleaner.

MAINTENANCE

Should any technical problems arise, contact a qualified professional
(recognised or authorised by the dealer or manufacturer) or your
local dealer.
All operations on the appliance must be carried out by a qualified
professional who before performing maintenance must make sure the
appliance is turned off, cold and disconnected from the household mains.
The appliance contains a precise quantity of special fluid. All repairs
requiring the appliance to be opened must be performed by a
qualified professional.
In the event of fluid leaks, contact your local dealer or a qualified
professional.
DISPOSAL
This symbol is known as the 'Crossed-out Wheelie Bin Symbol'. When this
symbol is marked on a product or battery, it means that it should not be
disposed of with your general household waste.
Some chemicals contained within electrical/electronic products or
batteries can be harmful to health and the environment. Only dispose of
electrical/electronic/battery items in separate collection schemes, which
cater for the recovery and recycling of materials contained within. Your
co-operation is vital to ensure the success of these schemes and for the
protection of the environment.
ELECTRICAL CONNECTIONS WITH PLUG
Before plugging into the mains socket, make sure that the voltage of your
mains power supply matches the V value reported on the rating plate of
the appliance and that the socket and power line are appropriate for the
required load (also reported on the rating plate).
Make sure that the power line is fitted with a disconnecting switch allowing
the appliance to be disconnected completely from the household mains, in
accordance with the regulation in force.
The power line must be fitted at least with a 30 mA RCD (high sensitivity
residual current protection device).
All the references about the "Pilot Wire" (Fil Pilote) mode and related
wiring present in the instruction manual must be ignored, since operating
mode is not available on this product.