Quick Installation - Tripp-Lite SmartPro SMART550USB Manuel Du Propriétaire

Quick Installation

1
Connect the UPS to an electrical
outlet.
Make sure the outlet does not share a
circuit with a heavy electrical load such as
an air conditioner or refrigerator.
2 Plug a computer, monitor and/or
other equipment into the
UPS system.
The UPS is designed to support only
computer equipment. Connecting high
power draw equipment such as household
appliances or laser printers to outlets
providing UPS battery backup will overload
the UPS. Special outlets (clearly labeled
on the rear panel) provide surge-only (not
battery backup) protection designed for
laser printers and other high power draw
equipment.
"UPS/Surge" receptacles are used to
provide connected equipment with AC
line power during normal operation and
battery power during blackouts and
brownouts. They also protect equipment
against damaging surges and line noise.
Connect the computer and monitor to the
"UPS/Surge" receptacles.
3 Select UPS Operating Mode.
Press the ON/OFF button to toggle the
UPS between the ON ("
the OFF (" " LED not lit) modes.
18-06-122-932616.indb 4
1
2
" LED lit) and
3
4
NORM DELAY
7/12/2018 4:39:33 PM