CyberPower Professional Rack Mount LCD Serie Manuel D'utilisation page 9

1. General Mode:
a. Press the "Display-Toggle" button to check the status of the UPS status:
b. Press and hold the "Display-Toggle" button for 4 seconds,
If the machine is in the Battery Mode with active alarm, it will become silent.
If the machine is in the Line Mode, a self- diagnostic test will take place.
c. If the "Display-Toggle" button remains untouched for over 30 seconds, the LCD backlight will turn off
automatically.
2. Set-up Mode
Step 1: Hold the "Display-Toggle" button for 10 seconds to enter the UPS Set-Up Mode.
Step 2: By pressing the Display toggle, users can switch between setup functions. Some User Configurable
functions are as follows:
a. Sensitivity: Set the level of tolerance for UPS. Increase the UPS compatibility for local utility power
condition.
High: The UPS will turn to battery power more often to provide the steady power supply to the
connected equipment.
Low: The UPS will tolerate more fluctuations and turn to battery power less often.
b. Battery Pack Numbers: This function provides the estimated UPS runtime using various numbers of
battery packs. The default setting is 0.
c. Voltage Mode: The AC output voltage on battery mode. There are 3 different settings (220,230,240).
These programmable items are sorted by unit as in the following table:
Step 3: Press and hold the display-toggle for 4 seconds. When the icons blink, the value of each item is
changed by slightly pressing the toggle.
Step 4: To save the value and return to general mode, press and hold the toggle for 4 seconds.
Copyright © 2016 CyberPower Systems, Inc.
LCD SETUP FUCTIONS
Item
1 Input Voltage
2 Output Voltage
3 Output Frequency
4 Load
5 Estimate Run Time
6 Load Capacity
7 Battery Capacity
8 Centigrade
9 Fahrenheit
Items
Sensitivity
Battery Pack Numbers
Voltage Mode (220/230/240)
Firmware Version
Unit
V
V
Hz
Kw
Min
%
%
° C
° F
Unit
None
A
V
None
8