System Block Diagram - CyberPower Professional Rack Mount LCD Serie Manuel D'utilisation

INSTALLING YOUR UPS SYSTEM
UNPACKING
The box should contain the following:
®
(1) UPS unit x 1; (2) User manual x 1; (3) Phone line x 1; (4) PowerPanel Business Edition software CD x 1; (5)
USB A+B type cable x 1; (6) Rack mount Brackets x 2; (7) Skids x 2; (8) Emergency Power Off Cable (gray) x 1;
(9) Serial Interface Cable (DB-9) x 1; (10) Power cord x 6
AUTOMATIC VOLTAGE REGULATOR(AVR)
The PR3000ELCDRT2U can stabiliz the consistent utility power. The utility power
may be damaging to important data and hardware, but Automatic Voltage
Regulation helps the computer not experience dangerous voltage levels.
Automatic Voltage Regulator automatically regulates low or high voltages to keep
equipment working at safe AC power levels (220/230/240V) without switching to
battery. Your equipment can operate normally even meet the power problems,
such as, shout brownouts and blackouts. The unit's powerful sealed lead-acid
batteries will provide power only if the incoming voltage drops below 150V or
increases above 300V.
INSTALLING YOUR UPS SYSTEM (continued)

SYSTEM BLOCK DIAGRAM

HARDWARE INSTALLATION GUIDE
1. Battery charge loss may occur during shipping and storage. For the first time the UPS is used, it's strongly
recommended to charge batteries for at least 12 hours is recommended to ensure that the batteries' maximum
charge capacity. To recharge the batteries, simply make the UPS plugs into an AC outlet.
2. When you use the included software, connect either the serial or the USB cable between the computer and
the corresponding port on the UPS. Note: If the USB port is used, the serial port will be disabled. They cannot
®
be used simultaneously. The computer with the PowerPanel Business Edition S/W connects to the USB port
or the Serial port on the UPS. It can control the operating schedule, battery test, outlet, etc. and get information
®
on the UPS status. However, other computers with PowerPanel Business Edition S/W can only get UPS
status information via a LAN connection.
3. With the UPS off and unplugged, connect your computer, monitor, and any externally powered data storage
device (Hard drive, Tape drive, etc.) into the outlets. DO NOT plug a laser printer, copier, space heater,
vacuum, paper shredder or other large electrical device into the UPS. The power demands of these devices will
overload and possibly damage the unit.
4. To protect a fax, telephone, modem line or network cable, connect the telephone or network cable from the
wall jack outlet to the jack marked "IN" of the UPS. Then, connect a telephone cable or network cable from the
jack marked "OUT" on the UPS to the modem, computer, telephone, fax machine, or network device.
Copyright © 2016 CyberPower Systems, Inc. 2