Installation And Wiring - Kenwood STZ-RF200WD Manuel D'instructions

Handling near electronic medical equipment
If used near electronic medical equipment such as implantable pacemakers or implantable
cardioverter-defibrillators, keep the unit at least 22 cm (8.664") from such equipment.
The radio waves may negatively affect the operations of medical devices.
Contact for malfunctions
If a malfunction occurs, stop use immediately and contact the office listed in this
manual. Continued use may result in unanticipated accidents, fires, or electric shocks.

Installation and Wiring

Do not install in locations subject to high-pressure water or locations with high lev-
els of humidity, dust, or soot
Water, soot, etc. entering the unit could result in smoke, fire, or malfunction.
Do not place items on top of the unit or that cover the unit.
Heat trapped inside the unit could result in fire or malfunction.
Cautions when handling cables
Make sure cables have sufficient slack so that they are not subject to excessive force, and
install them so that any sections that move do not bend beyond a radius of 40 mm (1.57").
Prevent cables from becoming damaged, pulled excessively, bent, twisted, modified,
pressed upon, installed near high-temperature equipment, etc. It could result in fires, elec-
tric shocks, and malfunctions from disconnections or shorts.
Cautions against deteriorated paint on the installation surface
Please check the paint on installation surfaces where double-sided tape will be affixed for
deterioration.
Deteriorated paint could reduce adhesion power and cause the unit to fall off.
The adhesion power of double-sided tape may affect the external appearance of the motorcycle.
Use
Do not use the unit for any non-vehicle use.
It could result in smoke, fire, or electric shock.
Check the installation before driving
A loose unit or connected component of the unit could fall or interfere with driving an cause
an injury or traffic accident.
If you notice malfunctions in the unit
If you notice that the unit is malfunctioning in any way, refer to the Troubleshooting section (p. 2 0)
to see if a solution is listed there. If you cannot find a solution, disconnect the power cable and restart
the unit. If operations do not return to normal after restarting, contact the office listed in this manual.
The unit is equipped with a GPS device.
Recorded drive data includes location information.
Caution
6