Motorsports Cam Functions; Function Settings; Recording Functions; Audio Settings - Kenwood STZ-RF200WD Manuel D'instructions

Powering the unit
When the bike's ignition is set to ACC or ON and the unit is switched on, the unit will start continuous
recording after completing a system check. When the ignition is turned to OFF, the unit will automatically
power off.
* The LED lights may illuminate for approximately 30 seconds while powering down which is normal.

Motorsports CAM Functions

The unit records videos and saves them to the microSD card.
Always insert an SD card into the SD card slot before using the unit.
See p. 1 1 for details.

Function settings

You can change the function settings for the unit using the KENWOOD Motorsports CAM App. See the
KENWOOD Motorsports CAM App Guide for details.

Recording functions

Continuous recording
The unit will start continuous recording when it powers on. The default setting is for each recorded minute
to be saved as a separate video file. The recording time can be changed with the KENWOOD Motorsports
CAM App.
Event recording
Event recording will start if a sudden force is detected during continuous recording. The unit will record
from 10 seconds before a large force affects the bike until 5 seconds after. The unit will return to continuous
recording after event recording has finished.
Manual recording
Manual recording will start if the switch button is pressed during continuous recording.
Saving and overwriting recorded files
Recorded files are saved separately as continuous recordings, event recordings, and manual recordings.
If the save region on the SD card becomes full, files on the SD card will be overwritten beginning with the
oldest file. See "Recording time" and "Possible number of files" (p. 2 4) for details.

Audio settings

Audio recording can be set to ON or OFF.
You can change the setting with the KENWOOD Motorsports CAM App.
15