Kenwood STZ-RF200WD Manuel D'instructions page 14

• Power cable
Each wire in the power cable assembly connects to the bike battery.
  U nscrew the battery's negative/ground terminal. Then unscrew the positive terminal.
  P lace the round terminal on the power cable (red wire) on the battery's positive terminal, then tight-
en with the original terminal screw.
Next, place the round terminal on the power cable (black wire) on the battery's negative terminal,
then tighten with the original terminal screw.
  W hen connecting the power cable's yellow wire, make sure that it is connected properly to the ACC
power supply.
• When unscrewing battery terminals, remove the negative one first, check that no cables are
contacting the terminal, and then remove the positive terminal. Connecting starts with the pos-
itive terminal.
• Remove the key from the ignition to prevent short circuiting the unit.
• Consult a professional installation technician if wire connections are causing problems. Incorrect
installation or wiring may severely damage the motorcycle or cause an accident.
• Install the fuse holder in a location where it will not come into contact with water.
• Connecting cables
Connecting cables
1. Check the pin layout of the in-line connectors and align the pins when connecting them.
2. Tighten the locking nut to secure the connection.
Locking nut
Disconnecting cables
1. Loosen the locking nut.
2. Hold the cable by the in-line connector and disconnect it.
• Holding the cable when disconnecting could damage the cable. Always hold the in-line connec-
tors to release a connection.
• Be careful to not mix up the cables for the front and rear cameras. Cables for the rear camera
have a white marker tube.
• Securing cables
Secure each cable to the motorcycle using cable ties or electrical tape.
Make sure they do not interfere with the rider's ability to control the bike.
• Check that the handlebar can rock back and forth and that the wires do not interfere with opera-
tions when the suspension bottoms out.
In-line connector
In-line connector
14
Cable
Cable