Kenwood STZ-RF200WD Manuel D'instructions page 12

Installing the unit
Installation layout
Switch
Front camera
• This installation layout is for reference. Actual installations will vary by motorcycle model.
• Main unit
Install the main unit underneath the seat.
  W hen fastening the main unit to the vehicle, check that there is adequate room to open the SD card
slot side door.
  U se the double-sided tape or hook-and-loop fastener as needed when fastening the main unit to the
vehicle.
• When using double-sided tape, affix it to the bottom (the flat sur-
face) of the main unit as shown in the image on the right.
• When using hook-and-loop fastener, affix it to the entire surface
of the bottom (the flat surface) of the main unit.
Hook-and-loop fastener may peel due to vibrations or impacts,
so use a location where impacts will not cause the unit to
dislodge.
• When installing the unit with double-sided tape, select a flat location on the vehicle, wipe away
any dirt or grease on the installation location with a commercially available cleaning cloth, and
install the unit after the location has dried. Reusing tape or using general purpose double-sided
tape for installation will provide less adhesive power and presents a risk of the unit falling off.
• Do not install in locations that will be subject to high temperatures (near the engine, muffler, etc.)
or high pressures (when the suspension bottoms out while someone is on the bike).
Main unit
GPS antenna
12
Install the main
unit with the cables
facing the front of
the vehicle.
Rear camera
Double-sided tape
Double-sided tape