Installation - Niko 16-72 Serie Mode D'emploi

16-72X

Installation

These receivers can be fixed onto any level surface thanks to a self-adhesive strip. The 4-pole
mini-jack plug can either be plugged directly into the IR-connection block (16-724), or the
4 signals can be accessed through the connector print (16-729) by means of the 4 screw
contacts (see 'WIRING AND INSTALLATION' p.86). If the cable of the receiver 16-721(2) is too
long for the installation, it can be shortened. To do this, the individual wires must be stripped.
Please make sure that the connections are made as indicated in the figure below.
EN 73