Assembly Instructions; Operating Instructions - MTD Yard Machines MTD308P Manuel De L'opérateur

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
NOTE: The only assembly required for your trimmer is to
install the debris shield and adjust the assist handle.
DEBRIS SHIELD INSTALLATION
1. Position the motor housing with string head carrier fac-
ing up (Figure 1).
2. Place the debris shield (A) on the tube so the holes
align with the slots on the bracket (B). (Figure 2)
3. Install the Shield knob and nut (C) and tighten secure-
ly.
A
CONNECT THE CORD
1. Ensure the cord is NOT plugged into a receptacle
before this procedure.
2. Make a loop with 8" - 10" (20 - 25cm) of the end of the
extension cord.
3. Place the loop into the slot (A) under the motor hous-
ing and lock into place with cord retainer (B) in Fig. 3
4. Connect the extension cord to the trimmer.
5. Plug the extension cord into a receptacle ONLY when
you are ready to operate the trimmer.

ASSEMBLY INSTRUCTIONS

B
Fig. 1

OPERATING INSTRUCTIONS

A
B
Fig. 3
www.mymowerparts.com www.mymowerparts.com
ADJUST THE ASSIST HANDLE
NOTE: The assist handle is attached to the shaft but has
been turned under for packing
1. Loosen adjustment knob and rotate handle to the top
of shaft (Figure 4).
2. Retighten adjustment knob securely.
7
C
Fig. 2
Fig. 4