Assembly Instructions - MTD Yard Machines MTD27P Manuel De L'opérateur

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
NOTE: The only assembly required for your trimmer is to
install the debris shield and the assist handle.
DEBRIS SHIELD INSTALLATION
1. Position the motor housing with stringhead carrier fac-
ing up (Figure 1).
2. Slide debris shield over motor housing as shown
(Figure 2).
3. Align edging guide with mating grooves and push firm-
ly in the direction shown until an audible snap is heard
(Figure 3).
NOTE: Be certain that edging guide is oriented as shown.
Once edging guide, motor housing and debris shield are
mated the connection is permanent and cannot be
removed without a special tool.

ASSEMBLY INSTRUCTIONS

Fig. 1
Fig. 2
Fig. 3
www.mymowerparts.com www.mymowerparts.com
ATTACH ASSIST HANDLE (Fig. 4 and Fig. 5)
1. Insert the handle in comfortable position and tighten
securely.
2. Before tightening completely, adjust the assist handle
height by sliding handle up or down tube. When assist
handle is at desired operating height, tighten it secure-
ly.
Assist Handle
Nut
7
Bolt
Fig. 4
Fig. 5