Assembly Instructions - MTD Yard Machines MCT33360E Manuel De L'utilisateur

On some units, the handle may installed, but is turned
down under to help in packaging. In this case you must
adjust the handle to fit the operator.
INSTALL / ADJUST THE HANDLE
1. Place the handle on the drive shaft.
2. Insert the bolt through the handle in secure it with
the washer an wing nut (Fig. 1).
3. Adjust the handle to fit the operator and tighten the
wing nut.
Shaft
Washer
Wing Nut
INSTALL THE CUTTING ATTACHMENT SHIELD
NOTE: The cutting attachment shield must be installed
to properly dispense the trimming line.
To install the cutting attachment shield:
1. Place the cutting attachment shield onto the shaft
bracket (Fig. 2).
WARNING:
cutting attachment shield in place to pre-
vent serious personal injury.
Cutting Attachment
Shield

ASSEMBLY INSTRUCTIONS

Handle
Bolt
Fig. 1
Never operate the
trimmer without the
Bracket
Fig. 2
2. Insert the bolt through the shield, bracket, washer
and lock washer tighten with the wing nut (Fig. 3).
EDGE GUIDE WHEEL
1. Push edge guide wheel onto the shaft (Fig. 4). Some
force may be required.
2. Install the bolt, washer and wing nut and tighten
securely.
3. Adjust the edging depth by loosening the depth
adjustment nut. Then move the guide wheel along
the path shown by the arrows to the desired position
(Fig. 4). Tighten securely.
Wing Nut
Depth
Adjustment
Nut
Edge Guide
Wheel
Wing Nut
Lock Washer
Washer
Bolt
Fig. 3
Washer
Bolt
Fig. 4
7