Sun Microsystems Sun Ray Série Guide De L'utilisateur page 33

Note – The recommended method to change Display settings on the Sun Ray 150
enterprise appliance is through the utxconfig command, as described in
"Troubleshooting" on page en-8.
Sun Ray 150 Enterprise Appliance Settings Screen
FIGURE 6
To Use the Settings Screen
1. Open the Settings screen using one of the following methods:
Press Shift+Props on the keyboard.
Open a terminal window and type:
% /opt/SUNWut/bin/utsettings
The Settings screen appears after a few seconds.
2. Select the category, then the setting you want.
Contact your system administrator if you have questions.
Adjusting Screen Brightness
The Brightness buttons on the right panel of the Sun Ray 150 enterprise appliance
enable you to adjust the brightness of your display.
Sun Ray 150 Enterprise Appliance User's Guide en-13