Cleaning The Trimmer Attachment; Cleaning The Beard Styler Attachment - Philips S7000 Serie Mode D'emploi

Cleaning the trimmer attachment

Cleaning the beard styler attachment

Clean the trimmer attachment after each use.
1 Switch on the appliance with the trimmer
attachment attached.
2 Rinse the attachment under a warm tap.
3 After cleaning, switch off the appliance.
4 Carefully shake off excess water and let the
attachment air-dry completely.
Tip: For optimal performance, lubricate the teeth
of the attachment with a drop of sewing machine
oil every six months.
(S7710/26 only)
Clean the beard styler after each use.
1 Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off
the beard styler. Do not pull at the sides of the
comb.
2 Rinse the cut hairs off the cutting unit with
lukewarm water.
3 Rinse the cut hairs off the comb.
4 Remove the cutting unit from the beard styler
attachment. By pushing the cutting unit from
the beard styler attachment you can remove
any hairs that have accumulated inside the
beard styler. You can also rinse the back of the
cutting unit.
31
English