Oster BVSTDCZH13 Manuel D'instructions page 7

SETTING THE CLOCK AND DELAY BREW TIME
To Set the Clock:
1. Plug the power cord into a standard electrical outlet. The clock will
flash on the control panel to indicate that the time has not been
set yet.
2. Press and hold the HOUR and MINUTE buttons until you reach
the current time. The PM indicator will light at the top of the
display when a PM hour is shown (Figure 1).
The clock is now set!
NOTE: Pressing any button before setting the clock will cause the
clock to start keeping time from 12:00 a.m. You must set the clock if
you want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply
press the SET DELAY button (Figure 2) and,
set the brew time by pressing the HOUR and
MINUTE buttons (Figure 3). The PM indicator will
light at the top of the clock display when a PM
hour is shown.
Within a few seconds the display will change to
the current time.
The Delay Brew Time is now set.
To Activate the DELAY BREW:
1. Make sure the coffee chamber does not contain coffee and is
inserted properly into the Coffee Dispenser.
2. Prepare your Coffee Dispenser by adding water and ground
coffee.
3. Press the DELAY BREW button once (Figure 4). The Coffee
Dispenser is now set to automatically brew at the pre-set time.
4. Cancel the DELAY BREW setting by pressing the DELAY BREW
button so the light turns off.
As a safety feature, your Coffee Dispenser will NOT start
again automatically the next day. If you want your coffee to
brew at the same time the following day, simply add a new
filter, coffee and water and set DELAY BREW, by repeating
Steps 2 and 3 above.
Colado Program.
Colar
Ahora
Figure 2
English-6
PROGRAM PM
Colado Program.
Colar
Ahora
Figure 1
PROGRAM PM PM PROGRAM PM
Hora
Minuto
Programar
Colado Program.
Colar
Ahora
Apagado
Figure 3
PROGRAM PM
Colado Program.
Colar
Ahora
Figure 4
PM
Hora
Minuto
Programar
Apagado
PM
Hora
Minuto
Programar
Apagado
PM
Hora
Minuto
Programar
Apagado