Cedes cegard/Mini-MOD Manuel D'installation Et D'utilisation page 9

cegard/Mini-MOD
7. Maintenance
Although the cegard/Mini-MOD system does not need
periodical maintenance, a functional check at least
with every elevator maintenance check is strongly
recommended. This periodic functional test should consist
of the following: The optical sensor elements are clear of
dirt and dust. If necessary, clean the front surface with a
soft towel.
 Test the reopening function over the whole door area.
The door should reopen if an object is placed anywhere
between the sill and up to 1,800 mm (standard
configuration) above the sill.
 Clean the front surface of the receiver and emitter
with a soft towel from dust or dirt. This is especially
important when the door edges are installed before the
construction of the building is finished (perhaps weekly
during construction). To clean the surface with a towel,
it must be either dry or slightly moist, but not wet.
 Ensure the edges are fastened securely to the door
wings and slam post.
 Ensure the cables are routed properly as described in
the appropriate mounting kit installation instructions.
NOTICE
Damage to the optical elements
 Do not use any aggressive cleaning
solvents like acetone or trichloride or
mechanically abrasive towels to clean
the vision shields, the receiver edge (Rx)
or the transmitter edge (Tx) as these will
likely cause damage.
 We strongly recommend using standard
window cleaners or soap and water for
cleaning.
© CEDES | V 2.2
8. Disposal
The cegard/Mini-MOD system should only be replaced if a
similar door protection device is installed. Disposal should
be done through state of the art recycling technology
according to local rules and regulations.
There are no harmful materials used in the design and
manufacture of the light curtain. Traces of such dangerous
materials may be used in the electronic components but
not in quantities that are harmful to health.
English
9