Enerpac HXD Serie Notice D'emploi page 6

8
8
WARNING:
keep hands away from support arm and
working area during operation.
8
IMPORTANT:
rotates in the direction opposite the rotation
of the cassette.
WARNING:
maximum torque of cassettes
and reducer inserts to avoid
danger of cassette failure and
bolt-shearing. Maximum torque of cassettes
and reducer inserts are specified in tables
A1 A2
and on pages 12-15.
WARNING: Exceeding the maximum torque
for a bolt (nut) size will result in bolt shearing
and potential parts failure. These failures
could result in pieces being projected from
the wrench or bolting site. Failures will also
result in the torque wrench unit moving
rapidly away from the torquing point causing
potential injury to the operator.
IMPORTANT: When
connections always
manufacturers
engineering recommendations.
4.0 ASSEMBLING THE WRENCH
9
See . All parts must be free of dirt and
lubricated according TO paragraph 6.1.
Follow steps 1-5 below:
To avoid personal injury
The torque wrench always
Do not
making
consult
instructions or
9
exceed
1. Remove the two dowel pins (3) from the
wrench unit (1).
2. The lever of the cassette (4) must face
the contact surface in the wrench (1).
3. Insert the cassette (4) into the wrench
unit (1).
4. Secure the cassette (4) to the wrench
unit (1) using the two dowel pins (3). The
dowel pins must "click" into the correct
position.
5. When using reducer inserts, see
illustration
bolted
position of insert and holding ring into
the
the cassette.
the
6. Connect the Enerpac THC-700 series
3,5:1 safety twin hoses (10) to the swivel
hose connection (2).
WARNING: See
correct way to connect the hoses
between wrench and pump.
6
"CLICK"
5
on page 5, for correct
10
on page 7 for the