Troubleshooting - PowerSmith PGA2200i Manuel D'utilisation

WARNING:
Risk of electric shock. Before any troubleshooting, switch off the engine. Suspected
malfunctions are often due to causes that users can fix themselves. Therefore check the product using this section. In
most cases the problem can be solved quickly.
Problems
The fuel tank is empty.
The engine switch was set to OFF.
The oil was not enough.
Engine does not Spark plug is defective.
start
The engine is flooded.
The fuel tube is broken.
Air filter is dirty .
Spark plug is dirty .
Engine lack of
power
Fuel filter was blocked.
Valve tolerance is set incorrect.
Overload warning.
AC socket does
not work
Circuit protector engaged.
Overload warning.
DC (USB) socket
does not work
Circuit protector engaged.
If the knocking or pinging occurs
Generator makes under normal load, the problem may
be with the wrong gasoline being
used.
English

TROUBLESHOOTING

Probable Causes
Refuel the fuel tank with proper fuel.
Set the engine switch to the «RUN» position.
Refill the oil to the recommended level.
Clean the electrode or change with a new one.
Set the engine switch to the «RUN» position, remove
the spark plug and wipe up the fuel, then pull out
the starter rope 5-10 times to drain out the fuel in
cylinder. Reinstall the spark plug.
Contact with the local service for repair.
Clean the air filter.
Clean it.
Contact with the local service for repair.
Contact with the local service for help.
Disconnect the appliances, and then press the output
reset button.
Disconnect the appliances, press the AC breaker.
Disconnect all the appliances, and then press the
output reset button.
Disconnect the appliances, press the DC breaker.
Switch to a different brand of gasoline, making sure
that the octane rating is 86 or higher. If problem
continues, contact your nearest authorised service
centre.
23
Solutions