PowerSmith PGA2200i Manuel D'utilisation page 19

CHANGING ENGINE OIL (FIG 14)
For best performance, engine oil should be changed after every 100 hours or 6 months of operation.
Drain the oil while the engine is still warm to assure rapid and complete draining.
1.
Loosen the cover screws and remove the maintenance cover.
2.
Remove the oil dipstick and wipe it clean.
3.
Drain dirty oil into a container thoroughly.
4.
Refill with the recommended oil, and check the oil level.
5.
Screw in the oil dipstick securely.
6.
Reinstall the maintenance cover and tighten the cover screws securely.
Wash your hands with soap and water after handing used oil.
Improper disposal of engine oil can be harmful to the environment. If you change the oil by yourself, please dispose of
it properly. Put it in a sealed container, and take it to a recycling center. Do not discard it in a trash bin, dump it on the
ground, or pour it down a drain.
CHECKING/CLEANING AIR FILTER (FIG 15)
A dirty air filter will restrict air flow to the carburetor. To prevent carburetor malfunction, service the air filter regularly.
Service more frequently when operating the generator in dusty areas. For proper performance and long life, keep air
filter clean.
WARNING:
Do not use gasoline or low flash point solvents for cleaning. They are flammable and
explosive under certain conditions.
1.
Loosen the maintenance cover screws and remove the
maintenance cover.
2.
Loosen the air filter cover screw and remove the air
cleaner cover.
3.
Wash the filter element in a solution of household
detergent and warm water, then rinse thoroughly or
wash in nonflammable or high flash point solvent. Allow
the filters to dry thoroughly.
4.
Reinstall the air filter.
5.
Reinstall the air filter cover, and tighten the air filter cover
screw.
6.
Reinstall the maintenance cover and tighten the cover
screws securely.
English
MAINTENANCE
19
FIG 14
FIG 15