SIM MIO FS11W1-EU Série Manuel D'utilisation page 8

 Speedometer：
Indicates riding speed there are two type of unit (Km/h) or (mph).
 LCD monitor (Including Odometer)：
Press "MODE" to switch showing the total mileage/ short mileage/ oil use.
Press "SET" to switch showing the battery voltage/ time.
 High Beam Indicator：
This indicator comes on with high beam headlight is turned on.
 Turn Signal Indicator：
The left or right Indicator will be flashing according to the operated directions of turn signal light switch
when it is turned on.
 Fuel Gauge：
The pointer in this gauge shows how much fuel remains in the tank.
If the pointer stays in "E" position when key switch is turned to "ON", please fill up with gasoline (over 92
Unleaded gasoline)
 EFi trouble warning indicator：
When turn the main switch to "ON", this warning indicator will come on and then go off after the
engine is running. It displays the condition of the EFi system is working correctly. If there is any
problem on the EFi system, the warning indicator will remain on all the time or does not come on.
Please contact with a SYM dealer to check the self-diagnosis system or electrical connections.
 Engine Oil Change Indicator：
This indicator shows when to change engine oil by light. Usually, the scooter has been ride
approximately 1,000 km, the indicator will show its light. Then, it means you should change or add the
engine oil, and turn the mileage to "0" in the OIL mode. After replacing it, please turn to KEY ON. Press
the "SET" 2 times in the "OIL" mode, let the indicator's light be off, and turn the mileage to "0" in the OIL
mode.
Notice: 1. Please change oil when the initial 300 km, then change every 1,000 km.
2. If your motor's mileage has already been exceeded the kilometers, but the light does not show,
please go to the SBC/ dealer store for check
Display mode switch:
1. When the key switch is turned to "ON" in "TOTAL" mode, Press "MODE" button within 1 second to
change between "TOTAL" , "OIL" and "TRIP" modes.
TOTAL
CLOCK
2. The "TOTAL" means the total mileage of the motor, cannot be reset. But in "TRIP" mode, and press the
SET" over 2 seconds, then the mileage can be erased and newly calculated.
3. Under "CLOCK" mode, press "SET" 1 second, will switch to "VOLTAGE" showing,
Time setting
1. Showing the 24 hour mode time (
2. When the key switch is turned to "ON," the clock will show the 24 hour mode hour/ minute .
3. Under the "CLOCK" mode, press " MODE" button (over 2 seconds) to enter "TIME" setup mode,
Then press "MODE" 1 second, then you could switch setup mode (as below):
HOUR
2. Under time setting mode, press "SET" button shortly to increase the readings. The number will
increase 1 at one time, it will automatically leave the setup mode if you do not take action within
30 seconds.
TRIP
CLOCK
0:00~23:59
MIN(10min) MIN(1min)
OIL
CLOCK
). Time allows ±2 seconds tolerance.
7
7.Use of Each Component
OIL
VOLTAGE