Cub Cadet 49A70001100 Manuel D'utilisation page 8

Installing the Hose
1. Thread the upper end of the
hose (764-05275) securely
into the upper chute
support. There are two tabs
on the lower inside part of
the upper chute support to
allow for secure threading.
See Figure 21.
NOTE:
The hose and upper chute
support are left-hand threaded.
Thread counterclockwise until secure.
2. Slide the hose over the boot
assembly mounted on the cutting
deck, as shown in Figure 22.
3. Make sure the connection is
secure and there are no gaps
between the hose and the boot
assembly.
4. If open, close the grass catcher
cover prior to mowing.
ASSEMBLY & INSTALLATION
Install The Counter Weight
Figure 21
1.
Figure 22
2.
8
This front-weight kit is required when operating any compatible zero-turn
tractor models equipped with a grass collector. Failure to install this kit
may result in serious injury or death.
Before beginning installation, place the zero-turn tractor on a firm and
level surface, set the parking brake, place the PTO in the disengaged
(OFF) position, stop the motor and remove the ignition key to prevent
unintended starting.
Attach the RZT bagger weight
(719-04271A) and three weight
plates (789-02137) to the weight
hanger brackets (Left - 789-
04077, Right - 789-04078) with
two 3/8" hex head capscrews
(710-3085) and two nuts (712-
04065) as shown in Figure 23.
Visually center the weight bar
assembly on the tractor and using
two 7/16" hex head capscrews
(710-3279) and two nuts (712-
04065) secure the counter weight
assembly to the tractor as shown
in Figure 24.
WARNING
WARNING
Figure 23
Figure 24