Residual Risk Factors - Garland ROLL&COMB 302 W-V20 Manuel D'instructions

English
The manufacturer will not be in any case held
responsible for damages caused through an
inadequate or incorrect usage of this machine.
Do not overload the machine. Use the machine
for the work it has been designed for. The correct
machine usage will allow you to work better and in a
more secure way.
Do not run with the comber. Walk at the correct
speed that will allow the machine to do its job.
Do not use this machine if the ¨open¨ and ¨closed¨
switch does not work. Any electric machine that
cannot be controlled by the electric switch is
dangerous and must be repaired.
Look after the machine. Check that all moving parts
are well aligned and that they are not blocked, that
there are no broken pieces or other conditions that
could affect the proper functioning of the machine.
If this machine is damaged, always repair it before
using it again. Most accidents occur because of poor
maintenance.
Maintain the moving elements clean. The moving
elements if clean will comber better, do a better job, have
less chance of getting tangled and easier to control.
Turn off and disconnect the machine from the
mains before carrying out any maintenance work
such as adjustments, cleaning, transportation (even
if you are just moving the machine from one working
area to another however close by this might be),
elevating the machine, maintenance or storage of the
machine. These simple security measures reduce the
risk of accidental start up.
Do not incline the machine with the engine running.
2.6. MAINTENANCE
Take your machine for periodic revision to a
qualified after sales dealer and only use original
spare parts and accessories. This will guarantee that
the security measures of this electris machine can
always be complied with.

2.7. RESIDUAL RISK FACTORS

Even when using the tool in the prescribed manner,
it is not possible to eliminate all residual risk factors.
The following risks may arise in relation to the
construction and design of the tool:
WARNING! This machine generates a field
electromagnetic during operation. This field can, in
some circumstances, interfere with passive or active
medical implants. To reduce the risk of serious or fatal
injury, people with medical implants should consult
their doctors and the implant manufacturer before
using this machine.
22/84