Ryobi RPW140H Mode D'emploi page 16

The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL SIGNAL
DANGER:
WARNING:
CAUTION:
CAUTION:
SERVICE
Servicing requires extreme care and knowledge and should be performed only by a qualified service technician. For
service we suggest you return the product to the nearest AUTHORIZED SERVICE CENTRE for repair. When servicing,
use only identical replacement parts.
WARNING:
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly
and understand completely the operator's
manual. If you do not under stand the warnings
and instructions in the operator's manual,
do not use this product. Call Ryobi customer
service for assistance.
WARNING:
The operation of any power tool can result in
foreign objects being thrown into your eyes,
which can result in severe eye damage. Before
beginning power tool operation, always wear
safety goggles or safety glasses with side
shields and, when needed, a full face shield.
SAVE THESE INSTRUCTIONS
ELECTRICAL
ELECTRICAL CONNECTION
This product has a precision-built electric motor. It should
be connected to a power supply that is 230-240 volts,
50 Hz, AC only (normal household current). Do not
operate this product on direct current (DC). A substantial
voltage drop will cause a loss of power and the motor will
overheat. If the product does not operate when plugged
into an outlet, double-check the power supply.
English(Original instructions)
MEANING
Indicates an imminently hazardous situation, which, if not avoided, will result in
death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, could result in
death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, may result in
minor or moderate injury.
(Without Safety Alert Symbol) Indicates a situation that may result in prop erty
damage.
14
EXTENSION CORDS
See Figure 1.
The cross-section of any extension cables used must be
proportional to their length, i.e. the longer the extension
cable, the greater the cross-section; cables with a
protection level of "IPX5" must be used.
Use the chart to determine the minimum wire size
required in an extension cord.
Extension cable
Voltage
up to 25m
Motor
230-240v
3 x 1.5mm²
WARNING:
Keep the extension cord clear of the working
area. Position the cord so that it will not get
caught on lumber, tools, or other obstructions
while you are working with a power tool. Failure
to do so can result in serious personal injury.
WARNING:
Check extension cords before each use. If
damaged replace immediately. Never use the
product with a damaged cord since touching
the damaged area could cause electrical shock
resulting in serious injury.
Extension cable
up to 50m
section section
3 x 2.5mm²