Operation - Klarstein ARTIKELNAME Mode D'emploi

EN
20

OPERATION

1. Plug in the power, click the ice machine key, the ice maker starts running.
2. The supply electrovalve will open and the water level float will floating with water ,
when the water reach the required water level the supply electrovalve will turn off,
and the machine will start the cleaning process , after cleaning completed it enter
the ice making process automatically .
3. When the ice thickness reaches the set thickness, the ice-free program starts,
the solenoid valve starts to work, the pump stops working, the heat enters the
evaporator, and the ice falls about 1.5 minutes. When the ice falls the dam-board
will turn over and turn on the magnetic reed switch .When the magnetic reed switch
closed the machine will start the ice making again. When the reed switch is closed,
the machine enters the ice making process again.
4. The compressor will not stop during the ice making and ice removing process.
5. When the ice bucket full of ice, the reed switch can not be automatically closed,
the machine automatically stops working, when taking enough ice, reed switch re-
closed, the delay after 3 minutes the machine starts, re-enter the ice process.
Ice thickness adjustment
1. Press and hold the (+) button for 3 seconds to enter the settings. When the
temperature indicator flashes, use the (+) or (-) button to adjust the thickness of the
ice. Then press the (+) button to display the number of minutes. Each time you press
(+) again, the time is increased by 1 minute. The maximum time that can be set is
25 minutes in addition to the preset ice preparation time. The time is reduced by 1
minute each time the (-) button is pressed again. The maximum time that can be set
is -9 minutes and is subtracted from the preset ice preparation time. Increase the
time for thicker ice cubes and reduce it for thin ice cubes.
2. When the ice has been discarded and the new cycle starts, the values you have just
set are automatically taken over.
Switching the light on/off
Press and hold the - button for 3 seconds to turn on the lights and press the button to turn
off the lights again for 3 seconds.
Planned switch-on
1. In standby mode, press the TIMING button. „Timed" lights up and the remaining
time until power on is displayed in hours.
2. Press the +/ - buttons to adjust the remaining time until power is turned on.
3. Press the TIMING button again to deactivate the scheduled power-on.