Installation; Commissioning And Operation - Klarstein PARTYTIME Manuel

EN
20

INSTALLATION

1. Unpack the appliance, then check and make sure that all the accessories including
ice basket and ice scoop etc. are complete. Contact customer service if accessories
are missing.
2. Please ensure the ice cube maker is level and on a stable table or platform to avoid
malfunction.
3. The incline angle of the ice cube maker cabinet should not exceed 45° during
transportation or use. Do not turn the ice cube maker upside down. Doing so could
cause the compressor or refrigerating system to operate incorrectly. Please allow
time for the fluids in the compressor to settle after the ice cube maker is moved
or transported. Before using the ice cube maker for the first time, please wait for
2 hours after the appliance has been leveled and positioned in the proper place.
4. The appliance must be placed on a dry and level surface with sufficient ventilation,
far from heat sources such as ovens, heaters and corrosive gases. Keep a minimum
distance of 20 cm to all sides of the ice cube maker to ensure proper ventilation.
5. Do not fill the water reservoir with hot water. This may damage the ice cube maker.
It is best to fill the water reservoir with water of room temperature or lower.
6. Do not use the appliance at a very cold environment (lower than 5 °C).
7. Clean the appliance before use (see section "Cleaning and Care").

COMMISSIONING AND OPERATION

1. Ensure that the drain plug at the bottom of water reservoir is closed well.
2. Plug the ice cube maker into the wall outlet, the "Ice making" indicator
Note: If the appliance has been moved, allow the ice cube maker to rest for
30 minutes before plugging the power plug into the wall outlet.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with potable water only.
Note: Do not fill above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press the Size selection button
selected, the "Small ice cubes" indicator
selected, the "Large ice cubes" indicator
7. Press the Start/Stop button
8. The ice-making cycle will last approximately 7-15 minutes, depending on the
ambient temperature and water temperature.
to select the ice size. If small ice cubes are
lights up. When large ice cubes are
lights up.
and the ice making indicator
blinks.
lights solidly.