Kenwood KMM-BT332U Mode D'emploi page 22

Bluetooth®
The following operations may differ or be unavailable depending on the
connected phone.
To
First incoming call...
Answer a call
Reject a call
End a call
While talking on the first incoming call...
Answer another incoming call
and hold the current call
Reject another incoming call
While having two active calls...
End current call and activate
held call
Swap between the current call
and held call
Adjust the phone volume*1
[00] to [35] (Default: [15])
Switch between hands-free and
private talk modes*2
*1 This adjustment will not affect the volume of the other sources.
*2 Operations may vary according to the connected Bluetooth device.
16
ENGLISH
On the faceplate
Press or the volume knob or one of
the number buttons (1 to 6).
Press .
Press .
Press .
Press .
Press .
Press .
Turn the volume knob during a call.
Press 6 IW during a call.
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
[MIC GAIN] [–10] to [+10] ([–4]): The sensitivity of the microphone increases as
the number increases.
[NR LEVEL] [LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
[ECHO CANCEL] [LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the echo cancellation
delay time until the least echo is being heard during a phone
conversation.
• Call quality may depend on mobile phone.
Make the setting for answering a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select [SETTINGS], then press the knob.
3 Turn the volume knob to select [AUTO ANSWER], then press the knob.
4 Turn the volume knob to select the time (in seconds) for the unit to
answer the call automatically, then press the knob.
[01] to [30], or select [OFF] to cancels. (Default: [OFF])
5
Press and hold to exit.
To return to the previous setting item, press
.
Default: [XX]
.