Hach SP-510 Manuel D'utilisation page 8

Analyseur de dureté

Masquer les pouces Voir aussi pour SP-510:

Table des Matières

Les langues disponibles

Figure 2 Product components

1 SP-510 Hardness Monitor

2 Installation kit

3 Maintenance kit

4 Buffer solution

Section 4 Installation

Electrocution hazard. Always remove power to the instrument before making electrical connections.

Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the

document.

4.1 Install the instrument

Install this instrument on an indoor wall, away from direct sunlight.

• For a complete purge of the sample line during each cycle, install the instrument as close to the

sample point as possible.

• Leave sufficient clearance at the bottom and sides for tubing and cable connections.

Refer to

Figure 3

and

Refer to the installation kit documentation for more information.

Refer to the maintenance kit documentation for more information.

8 English

Figure

5 Indicator solution

6 Magnesium sulfate solution

7 TitraVer

(EDTA) hardness titrant

D A N G E R

Table des Matières

Dépannage