Maintenance; General Inspection; Warranty - SPARKY HD PROFESSIONAL BPR 18Li HD Notice Originale

Take the drill bit out of the opening from time to time to
remove dust.
Watch out for the stage of blunting of the bit and change it
if considerable decrease of efficiency is observed.
Do not operate the machine in «Hammer drilling» and
«Hammer» mode with the switch (7) in rightmost posi-
tion.
Depending on the processed material it is possible
that the impact energy may decrease during operation
in «Hammer» mode (chiselling and demolishing and in
«Hammer drilling» mode. To restore the maximum im-
pact energy it is necessary to reduce the revolutions by
decreasing the pressure on the switch trigger (9) until the
advent of stable impact.
Before drilling large-diameter holes in metal, first drill a
small pilot hole.
The optimum capacity for drilling in concrete with twist
drill bits is shown in the table with technical specifica-
tions.
The rotary hammer is suitable for light-duty chiselling.
Higher durability and efficiency can be achieved only
when using sharp chisels.

Maintenance

WARNING: Always ensure that the tool is
switched off and remove the battery before attempting
to perform inspection or maintenance.

GENERAL INSPECTION

Regularly inspect all fasteners and ensure they are
properly tightened. Should any of the screws be loose,
retighten it immediately to avoid hazards.
CLEANING
For safe operation always keep the machine and its ven-
tilation slots clean.
Regularly check to see if any dust or foreign matter has
entered the grills near the motor and around the switch-
es. Use a soft brush to remove any accumulated dust.
Wear safety glasses to protect your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a soft
damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into con-
tact with the tool.
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
certified service centres or other qualified service or-
ganisations, always using genuine replacement parts.
8
EN
pages-BPR 18Li HD.indd 8

Warranty

The guarantee period for SPARKY power tools is deter-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire original instructions before us-
ing this product.
The manufacturer reserves the right to change specifica-
tions without notice.
Specifications may differ from country to country.
BPR 18Li HD
10.7.2017 . 9:56:29