Grounding Instructions - noken I-COMFORT 100289923 Mode D'emploi

EN
sure the circuit you are connecting to the mirror, has been installed and protected to the installation
standards in force at your country.
5. To install a product that is not equipped with a plug, a switch device that can completely disconnect the power supply
of the product must be installed at the front end of the fixed wiring.
6. When it thunders,it is strongly recommended to pull out the power plug.
7. Do not stand on ceramic toilet.
8. Do not stand on product unit,seat and cover.
9. Do not lean against the seat cover when using the product,to avoid damage.
10. This product is equipped with soft-closing seal cover.Heavy pressing or pushing may damage the soft-closing
damper.
11. Do not use lacquer thinner,petrol,liquid medicine,detergent,insecticide,toilet cleanser and scrubbing brush to clean
the product.
12.Exposure to direct sunlight is prohibited.
13.Only use tap water or potable water;otherwise it may cause chafing.
14.Do not connect water supply to heater outlet.Make sure inlet water temperature at 3~35ºC.
15.When the room temperature is under zero degree,please dry up the water tank,to avoid freezing.
16.Raise rest room temperature to prevent the toilet from damage due to freezing.
17.When move the product from cold or wet environment into normal room temperature,wait for 2 hours until the con-
densation water is fully volatilized.Doing so can prevent the product from electrical short-circuit.
18.When not using the product over three(3) days,drain the water out of the container and pull the electrical plug from
the wall outlet.
19.Stop using the product and shut off the power when product malfunctions,please contact the service people for
professional service.

GROUNDING INSTRUCTIONS

This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock
by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with
a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
DANGER - Improper use of the grounding plug can result ina risk of electric stock
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either flat blade terminal.
The wire with insulation having an outer surface that is green with or without yellow stripes is the grounding wire.
5