Thermostat Storage Bracket - L.B. White Premier 40 Manuel Du Propriétaire Et Instructions D'installation

Thermostat Storage
Bracket Assembly
1. Thermostat Storage Bracket Assembly
a. Thread four 3/8 in. hex head screws into the
four holes at upper corner on heater's left side;
do NOT tighten at this time.
b. Slide the four keyholes of the thermostat
bracket mounting fl anges over the four screws.
Push the bracket downward, hold in place. In-
sert a 1/4 in. nut driver or standard screwdriver
through the bracket's access holes and tighten
screws securely. See FIG. 1.
FIG. 1
c. Store the thermostat within the bracket when
not in use. See Fig. 2.
FIG. 2
Premier Ductable Heater
Thermostat Assembly
(Part # 500-30125)
If thermostat is not needed or required, select
manual setting on thermostat switch. See Fig. 3.
FIG. 3
If a thermostat is required, remove the thermostat
outlet cover and plug the thermostat cord into the
thermostat outlet receptacle. Select thermostat set-
ting on the switch. See Fig. 4.
FIG. 4
* ALWAYS cover the thermostat outlet when not in
use.
* DO NOT plug an appliance into the thermostat
outlet.
Owner's Manual • Premier 40
13