EHEIM universal 300 Mode D'emploi page 17

BDA_EHEIM_universal_300_600_1200_2400_3400_4500_14.02.22.qxp_Teilenummer: 73 788 10 - 02.21 14.02.22 14
English
EHEIM universal 2400 / 3400 / 4500 (⌦ A3):
a b
Motor body Mounting plate
f
Pump cover with O-ring
k
cover Holding ring
5.
Assembly
For use outside the water, a hose is preferably used on the suction side (⌦ B) via the threaded connection
If the pump is used inside the water as a submersible pump (⌦ C), it may only be operated via the suction grille
h
and the coarse filter
suction opening is covered with the enclosed sealing cover
For versions suitable for outdoor use only
Placement in the pond on a stable base, e.g. garden slab or similar. Do not place in the ground (mulm!).
Only for EHEIM universal2400 and 3400 (suitable for outdoor use)
l
The carrying handle
When used in ponds, the carrying handle serves as a rope attachment (⌦ D + E).
b
The mounting plate
Only for EHEIM universal 1200
The two mounting strips
pulled out and optionally pushed into another guide. To do this, first remove (⌦ G) the covers
bevels of the motor body
ATTENTION!
The threaded connection on the pressure side
6.
Commissioning
For use outside the water:
Mount the appropriate hose on the threaded connection on the pressure side and suck on the end of the hose until
water flows into the pump. Only when the pump chamber is completely filled with water, insert the mains plug into
the mains socket and start the unit. A short starting noise of the pump is normal (⌦ B).
When used inside the water (submersible pump):
Submerge the pump completely into the water, then plug the power plug into the power socket and start the unit
(⌦ C).
ATTENTION!
Observe the minimum immersion depth of 2 cm from the water surface to the upper edge of the pump.
7. Maintenance and care
DANGER! Electrocution!
• Always disconnect all devices from the mains before carrying out maintenance work.
CAUTION! Damage to property.
• Do not use hard objects or aggressive cleaning agents for cleaning. The unit components are not dish-
washer-safe!
• Cleaning the unit or parts of the appliance not in the dishwasher.
c
Threaded connection on discharge side
g h
Coarse filter Intake grille
l
Carrying handle, for outdoor version only
g
. The threaded connection on the suction side
is inserted from the front into the upper groove of the motor body
can be attached at 3 different points (⌦ F) for universal pump mounting.
b
can be moved for universal pump mounting. After loosening the catch, the strip can be
a
.
d
Pump wheel
i
Threaded connections on the intake side
i
is unscrewed for this purpose and the
j
.
c
must not point downwards. (⌦ H)
17
e
Ceramic shaft
j
Sealing
i
.
a
.
l
on the upper