Erreka VULCAN VU31LB Manuel De L'installateur page 31

Before installing the operator, check that the
actuated part is in a good mechanical
condition, that it is correctly balanced, and
that it opens and closes correctly.
None of the hazardous parts of the operator
are designed to be installed at more than 2.5
m above ground level or other access levels.
The operator cannot be used with an actuated
part with a pedestrian door unless it is able to
make the pedestrian door work safely by itself.
Ensure that any trapping between the
actuated part and the surrounding fixed parts
due to the opening movement of the actuated
part is avoided (except for pedestrian doors
that move horizontally).
Ensure that any trapping between the
actuated part and the surrounding fixed parts
due to the movement of the actuated part is
avoided for pedestrian doors that move
horizontally. This can be achieved if the
applicable distance is less than 8 mm.
However, the following distances are
considered sufficient to avoid any trapping of
the parts of the body indicated below:
• For fingers, a distance over 25 mm
• For feet, a distance over 50 mm
• For heads, a distance over 300 mm
• For the whole body, a distance over 500
mm
Protection is required if these distances cannot
be achieved.
The operator's installation details are shown in
the "Installation" chapter of this guide. If
he product should be dismantled by qualified
T
personnel at the end of its working life.
This product consists of a variety of materials,
some of which can be recycled and others
which must be disposed of. Users must be
aware of the different recycling and disposal
systems envisaged in local regulations.
deformable edges or protective devices not
supplied with this unit are installed, see the
instructions for these components.
The actuating element of a hold-down switch
must be placed in direct view of the actuated
part but away from the moving parts. Unless
operated with a key, it must be installed at a
minimum height of 1.5 m and inaccessible to
the public.
Details on how to adjust the controls are
s h o w n i n t h e r e l e v a n t s e c t i o n o f t h e
instructions manual for the ERREKA control
panel used.
Once installed, ensure the mechanism is
regulated correctly and the protection system
and any manual release devices work properly.
Permanently affix the label for the manual
release device next to the appropriate
element.
The list of all components included in the
operator is shown in the "Unpacking and
content" section of this guide.
The specification of the type of door, gate,
garage door or window the operator is
intended for, the size and mass of the
actuated part or the mass of the actuated part
and required torque are shown in the section
"Technical characteristics of the operator".
The positions the operator can be installed in
are shown in the "Installation" section of this
guide.
WARNINGS FOR SCRAP
Some parts of this product may contain
contaminating or hazardous substances
w h i c h , i f r e l e a s e d , c o u l d h a r m t h e
environment and human health.
GENERAL SAFETY INSTRUCTIONS
Discarding this device along with
household waste is forbidden. Carry
out selective sorting according to
local regulations.
VULCAN hydraulic operator
31