ASSEMBLY STEP 3
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
8
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
MAIN FRAME
CRANK
PEDAL ARM
GUIDE RAIL
PEDAL ARM WHEEL
WAVY WASHER (G)
22.5 mm
Qty: 2
Open hardware bag 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
gently slide the console mast onto the
C
main frame and attach console mast to
main frame using pre-installed bolts.
Slide wavy washer (g) over crank
D
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the crank using 1
E
flat washer (h), 1 spring washer (i)
and 1 bolt (J).
WAVY WASHER (G)
FLAT WASHER (H)
Repeat steps D–E on the opposite side of the
F
SPRING WASHER (I)
elliptical.
BOLT (J)
HARDWARE BAG 3 CONTENTS :
FLAT WASHER (H)
SPRING WASHER (I)
20 mm
15 mm
Qty: 2
Qty: 2
BOLT (J)
20 mm
Qty: 2