Accessories - Bosch TC10 Consignes De Fonctionnement/Sécurité

BM 2610019162 07-12_BM 2610019162 07-12.qxp 7/31/12 2:21 PM Page 25
Read instruction manual first! Remove plug from the power source before making adjust-
WARNING
ments or assembling accessories.
TROUBlE: MOTOR STOpS RUNNING
pROBlEM
1. There is no power to the electrical outlet.
2. Low voltage.
3. Plugs aren't fully connected to the power source.
4. Switch isn't "ON."
5. The carbon brushes have worn out completely.
6. GFCI is tripped.
REMEDY 1. Make sure that the outlet has power.
2. Check that the power source voltage is 120V.
3. Verify that the plugs are securely connected.
4. Lift the ON/OFF switch to turn the saw on.
5. Replace the carbon brushes.
6. Press the ON/OFF switch down to turn the saw off; reset the button on the GFCI.
TROUBlE: THE WATER pUMp CANNOT INJECT WATER
pROBlEM
1. The water-pump plug is not firmly connected to the saw receptacle.
2. There is not enough water in the water tray.
3. The water hose is loose or off.
4. The water hose or water nozzle is jammed.
5. The water pump filter is too dirty.
6. The water pump is damaged.
REMEDY
1. Connect the water-pump plug to the saw receptacle.
2. Make sure that the water-pump intake is fully immersed in water.
3. Reconnect the water hose to the pump.
4. Clean the water hose or water nozzle, or replace them.
5. Clean the water-pump filter.
6. Replace the water pump.
GTA10 - Folding Leg Tile Saw Stand
GTA10W - Folding Tile Saw Stand w/Wheels
1609B03010 - Replacement Pump
Trouble Shooting

Accessories

-25-