Bosch TC10 Consignes De Fonctionnement/Sécurité page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BM 2610019162 07-12_BM 2610019162 07-12.qxp 7/31/12 2:21 PM Page 12
Installing the Water pump
To reduce the risk of electrical
WARNING
shock, only connect the pump to
the tile saw.
Risk of electric shock- This
WARNING
pump has not been investigated
for use in swimming pool or marine areas.
This pump has been evaluated
CAUTION
for use with water only.
1. Connect the end of the water hose to the water
outlet on the water pump (Fig. 2).
FIG. 2
2. Locate the water-pump-positioning tabs in the
water tray. With the water tray in place beneath the
saw, position the water pump as shown in (Fig. 2.)
Press the water pump in place to secure it to the
water tray with the attached suction cups.
3. Connect the water-pump power cord to the recep-
tacle on the saw, as shown in (Fig. 3).
4. Locate the 4 clips in the 2 grooves beneath the
rails, close to the motor-mounting arm (Fig. 4). Use
2 clips to lock the water hose into one groove and
2 clips to lock the power cable into the other
groove, as shown in (Fig. 4).
Assembly
FIG. 3
FIG. 4
-12-

Publicité

Table des Matières
loading

Table des Matières