Data Transmission; Selecting The Channel - Alcad 905-ZA Série Manuel D'installation Et Programmation

40 - ENG
programming indicator (25)(37) of the previous module and lighting up that
of the current module.
Programming mode will be automatically deactivated if no programming or
reading operation has occurred in the equipment for a period of 3 minutes.
6.2

Data transmission

Select the desired function on the screen of the PS programmer and set the
correct value for this function.
To transmit the data, press the T key. The programming indicator of the
module (25)(37) and the PRG indicator (12) will blink to indicate that the
module has received the data. Moreover, the transmitted data is memorised
in the PS programmer.
FM/DAB
PRG
6.3

Selecting the channel

Double filter:
With the option Mode: F1, you can select whether you wish to work with
analogue or digital channels and enter the channels or frequencies.
If the number of channels received from an antenna is an odd number, you
can cancel a filter by entering 0 in the option Channel F1 B/G CCIR
C21or Channel F1 B/G CCIR 471.25 MHz; the screen will then
show Channel F1 Off or Frequency F1 Off.
In analogue mode:
The message Channel F1 B/G CCIR C21 on the screen of the PS
programmer means that you can configure the filter of the module as a
monochannel filter.
Installation and programming manual
UHF
OUT
Fig. 10 – Data transmission
IN
PRG