Adjusting The Brightness; Automatic Brightness Adjustment; Manual Brightness Adjustment - Elmo L-1ex Mode D'emploi

Adjusting the brightness

P r e s s t h e [ B R I G H T N E S S
[ B R I G H T N E S S
operating panel or on the remote control to
adjust image brightness.The following two
adjustment modes can be set by selecting
[Brightness] from the OSD menu.
■

Automatic brightness adjustment

([Brightness] → [Auto] in the OSD) The brightness of the
image changes automatically according to the brightness of
the object.
■

Manual brightness adjustment

([Brightness] → [Manual] in the OSD)
The brightness of the image is fixed to the specified level.
N o t e
• Factory setting is set to [Auto].
• Manual adjustment fixes the brightness and does not adjust to changes in
brightness of the object.
• When the brightness becomes dark, the frame rate slows, and the image may
become hard to see.
• By setting [Guide] to [On] in the OSD menu, the setting details are displayed on the screen.
• To go back to the factor y settings, press the [BRIGHTNESS
[BRIGHTNESS
same time, or set [Reset Brightness] from the OSD menu.
• In places where the object is exposed to bright sunlight
(e.g. near a window), or extremely bright lights, the
brightness of the screen may not dim sufficiently, even
when the [BRIGHTNESS
In such cases, adjust the amount of light by closing the
curtains or moving the source of the light.
] o r
] b u t t o n s o n t h e
] buttons on the operating panel at the
] button is pressed.
English
Auto
> Manual
] and
121