Installation; Safety Information For Installation; Requirements For The Installation Location - Berbel BMK-F 125 Manuel De Montage

Installation

3. Installation
3.1

Safety information for installation

D WARNING!
Hazard through disregard of the installation instructions!
This chapter contains important information for the safe
installation of the device.
☞ Read through this chapter carefully before installing the
device.
☞ Follow the safety instructions.
☞ Carry out the installation as described.
y Installation only by qualified specialist personnel.
D "1.2 Authorised target groups" (page 76).
y Electrical work only to be undertaken by qualified
electricians.
D "1.2 Authorised target groups" (page 76).
y When working at heights, ensure good stable footing
(e.g. stable stepladder).
y Store the film or other parts of the packaging in a location
which is inaccessible to children.
y The device must be in an undamaged and fault-free
condition prior to installation.
y Cables must not be kinked, crushed or damaged.
y It is not permissible to attach further components
(e.g. panels, air ducts) to the device.
y The power supply voltage must match the voltage
information quoted on the ratings plate.
D "2.4 Technical data" (page 78).
y Ensure that the power supply is stable and remains so
prior to the installation.
Connect the power supply only when instructed to do so
in the installation instructions.
6005770_d – 21.12.2021
3.2

Requirements for the installation location

D WARNING!
Risk of death due to improper installation!
Disregard of the ambient conditions can lead to hazardous
situations, e.g. in the handling of electrical power or gas.
☞ Make sure that the requirements for the installation
location are complied with.
y Do not install in potentially explosive atmospheres.
y In extracted air mode and whilst using a heating point
which uses air from the room as its oxygen supply (e.g.
chimney):
y A safety device is absolutely essential.
y The safety device must prevent gases being drawing
to the room.
y It is essential to ensure that the negative pressure
in the heating point installation room does not
exceed 4 Pa.
y An approval for commissioning (e.g. from a
chimneysweep) must be available.
y Installation is only permitted on structural building
elements capable of bearing the load (solid structure).
y Installation is only permitted on vertical outside walls.
y Suitable fastening materials must be used if the outside
wall is insulated.
y Make sure that the building electrical supply is properly
earthed.
y The power supply voltage present must match the
voltage information quoted on the ratings plate.
y Inside the building, there must be a max. distance of 1 m
between the device and a 230 V socket.
y The air flowing out must be able to dissipate unimpeded.
Do not impede the air flow, e.g. through the installation of
objects on or above the device.
 Country-specific, legal provisions must be observed.
79